12.4. Establishing a Modem Connection

A modem can be used to configure an Internet connection over an active phone line. An Internet Service Provider (ISP) account (also called a dial-up account) is required.

To add a modem connection, follow these steps:

1. Click the Devices tab.

2. Click the New button on the toolbar.

3. Select Modem connection from the Device Type list, and click Forward.

4. If there is a modem already configured in the hardware list (on the Hardware tab), the Network Administration Tool a modem is not found, a message is displayed to warn you that the settings shown are not values found from the probe.

5. After probing, the window in Figure 12-6 appears.

   

   Figure 12-6. Modem Settings

6. uncheck the corresponding checkbox. Click Forward.

7. If your ISP is in the pre-configured list, select it. Otherwise, enter the required information about your ISP account. If you do not know these values, contact your ISP. Click Forward.

8. On the IP Settings page, select whether to obtain an IP address via DHCP or whether to set on statically. Click Forward when finished.

9. On the Create Dialup Connection page, click Apply.

After configuring the modem device, it appears in the device list with the type Modem as shown in Figure 12-7.

Be sure to select File => Save to save the changes.

After adding the modem device, you can edit its configuration by selecting the device from the device list and clicking Edit more can also be changed.

When the device is added, it is not activated immediately, as seen by its Inactive status. To activate the device, select it from the device list, and click the Activate button. If the system is configured to activate the device when the computer starts (the default), this step does not have to be performed again.