2.6. GRUB Commands
that line by space characters.
The following is a list useful commands:
boot — Boots the operating system or chain loader that has been previously specified and loaded.
chainloader <file-name> — Loads the specified file as a chain loader. To grab the file at the first sector of the specified partition, use +1 as the file's name.
displaymem— Displays the current use of memory, based on information from the BIOS. This is useful to determine how much RAM a system has prior to booting it.
initrd <file-name> — Enables users to specify an initial RAM disk to use when booting. An initrd
install <stage-1> <install-disk> <stage-2> p <config-file> — Installs GRUB to the system MBR.
When using the install command the user must specify the following:
<stage-1> — Signifies a device, partition, and file where the first boot loader image can be found, such as (hd0,0)/grub/stage1.
<install-disk> — Specifies the disk where the stage 1 boot loader should be installed, such as (hd0).
<stage-2> — Passes to the stage 1 boot loader the location of the stage 2 boot loader is located, such as (hd0,0)/grub/stage2.
p <config-file> — This option tells the install command to look for the menu configuration file specified by <config-file>. An example of a valid path to the configuration file is (hd0,0)/grub/grub.conf.
Warning The install
kernel <kernel-file-name> <option-1> <option-N> — Specifies the kernel file to load from GRUB's root file system when using direct loading to boot the operating system. Options can follow the kernel command and will be passed to the kernel when it is loaded.
For Red Hat Linux, an example kernel command looks like the following:
kernel /vmlinuz root=/dev/hda5
This line specifies that the vmlinuz file is loaded from GRUB's root file system, such as (hd0,0). An option is also passed to the kernel specifying that when loading the root file system for the Linux kernel, it should be on hda5, the fifth partition on the first IDE hard drive. Multiple options may be placed after this option, if needed.
root <device-and-partition> — Configures GRUB's root partition to be a specific device and partition, such as (hd0,0), and mounts the partition so that files can be read.
rootnoverify <device-and-partition> — Performs the same functions as the root command but does not mount the partition.
Commands other than these are available. Type info grub for a full list of commands.
| Главная |