2.9. Options in /etc/lilo.conf

The LILO configuration file is /etc/lilo.conf. The /sbin/lilo commands uses this file to determine what information to write to the MBR.

	Warning
	Before editing /etc/lilo.confmkbootdisk for more information on creating a boot disk.

The /etc/lilo.conf file is used by the /sbin/lilo command to determine which operating system or kernel to load and where it should be installed.

A sample /etc/lilo.conf file looks like this:

boot=/dev/hda
map=/boot/map
install=/boot/boot.b
prompt
timeout=50
message=/boot/message
lba32
default=linux

image=/boot/vmlinuz-2.4.0-0.43.6
	label=linux
	initrd=/boot/initrd-2.4.0-0.43.6.img
	read-only
	root=/dev/hda5

other=/dev/hda1
	label=dos

• boot=/dev/hda — Instructs LILO to install itself on the first hard disk of the first IDE controller.

• map=/boot/map — Locates the map file. In normal use, this should not be modified.

• install=/boot/boot.b — Instructs LILO to install the specified file as the new boot sector. In normal use, this should not be altered. If the install line is missing, LILO will assume a default of /boot/boot.b as the file to be used.

• prompt — Instructs LILO to show you whatever is referenced in the message line. While it is not recommended that you remove the prompt line, if you do remove it, you can still access a prompt by holding down the [Shift] key while your machine starts to boot.

• timeout=50 — Sets the amount of time that LILO will wait for user input before proceeding with booting the default line entry. This is measured in tenths of a second, with 50 as the default.

• message=/boot/message — Refers to the screen that LILO displays to let you select the operating system or kernel to boot.

• lba32 — Describes the hard disk geometry to LILO. Another common entry here is linear

• default=linux — Refers to the default operating system for LILO to boot as seen in the options listed below this line. The name linux refers to the label line below in each of the boot options.

• image=/boot/vmlinuz-2.4.0-0.43.6 — Specifies which Linux kernel to boot with this particular boot option.

• label=linux — Names the operating system option in the LILO screen. In this case, it is also the name referred to by the default line.

• initrd=/boot/initrd-2.4.0-0.43.6.img — Refers to the initial ram disk necessary to operate a SCSI card, hard drive, or any other device needed to load the kernel. You should never try to share initial ram disks between machines.

• read-only — Specifies that the root partition (see the root line below) is read-only and cannot be altered during the boot process.

• root=/dev/hda5 — Specifies which disk partition to use as the root partition.

• other=/dev/hda1 — Specifies the partition containing DOS.